Arduino Compatible Nano V4
4 stars based on
They operate at 5 volts. Each pin can provide or receive a maximum of 40 mA and has an internal pull-up resistor disconnected by default of kOhms.
In addition, some pins have specialized functions:. The Nano has 8 analog inputs, each of which provide 10 bits of resolution i. By default they measure from ground to 5 volts, though is it possible to change the upper end of their range using the analogReference function. Additionally, some pins have specialized deek robot arduino nano v3.
The Arduino Nano has a number of facilities for communicating with a computer, another Arduino, or other microcontrollers. A P on the board channels this serial communication over USB and the drivers provide a virtual com port to software on the computer.
The Arduino software includes a serial monitor which allows simple textual data to be sent to and from the Arduino board. A Deek robot arduino nano v3 library allows for serial communication on any of the Nano's digital pins. The Arduino software includes a Wire library to simplify use of the I2C bus. The ATmega on the Arduino Nano comes preburned with a bootloader that allows you to upload new code to it without the use of an external hardware programmer.
It communicates using the original STK protocol. Rather then requiring a physical press of the reset button before an upload, the Arduino Nano is designed in a way that allows it to be reset by software running on a connected computer.
When this line is asserted taken lowthe reset line drops long enough to reset the chip. The Arduino deek robot arduino nano v3 uses this capability to allow you to upload code by simply pressing the upload button in the Arduino environment. This means that the bootloader can have a shorter timeout, as the lowering of DTR can be well-coordinated with the deek robot arduino nano v3 of the upload. This setup has other implications. For the following half-second or so, the bootloader is running on the Nano.
While it is programmed to ignore malformed data i. If a sketch running on the board receives one-time configuration or other data when it first starts, make sure that the software with which deek robot arduino nano v3 communicates waits a second after deek robot arduino nano v3 the connection and before sending this data. Only registered users can write reviews. Please, log in or register.
Powered by Magento extensions. Terminal Adapter for Nano V3. Your Shopping cart is empty. Quick Overview Set includes: Input and Output Each of the 14 digital pins on the Nano can be used as an input or output, using pinModedigitalWriteand digitalRead functions. In addition, some pins have specialized functions: These pins can be configured to trigger an interrupt on a low value, a rising or falling edge, or a change in value.
See the attachInterrupt function for details. Provide 8-bit PWM output with the analogWrite function. These pins support SPI communication, which, although provided by the underlying hardware, is not currently included in the Arduino language. There is a built-in LED connected to digital pin Additionally, some pins have specialized functionality: There are a couple of other pins on the board: Reference voltage for the analog inputs.
Bring this line LOW to reset the microcontroller. Typically used to add a reset button to shields which block the one on the board. Communication The Arduino Nano has a number of facilities for communicating with a computer, deek robot arduino nano v3 Arduino, or other microcontrollers. Programming The Arduino Nano can be programmed with the Arduino software. Automatic Software Reset Rather then requiring a physical press of the reset button before an upload, the Arduino Nano is designed in a way that allows it to be reset by software running on a connected computer.
SKU P Weight 0. Write Your Own Review Only registered users can write reviews. You have no items in your shopping cart.